Analog, power and mixed-signal
The 555 timer, the 741 op-amp, voltage regulators, data converters and power chips. 121 chips on EveryChip so far.
Analog chips handle signals that vary smoothly, such as sound, temperature, voltage and radio, rather than ones and zeros. Amplifiers, voltage regulators, timers, data converters and power-management chips are all analog or mixed-signal parts. Some designs are decades old and still sold in billions, such as the 555 timer of 1972 and the 741 operational amplifier of 1968. Texas Instruments and Analog Devices are the largest makers.
Classic parts
An operational amplifier (op-amp) boosts the difference between two voltages and, with a few resistors, can amplify, filter or add signals. Fairchild's μA741 became the standard op-amp. The 555, designed by Hans Camenzind for Signetics, makes pulses and delays with a few outside parts. Linear regulators such as the 78xx series and the LM317 turn a rough supply into a steady voltage.
Power and data converters
Today the largest analog markets are power management, which converts and distributes battery or mains power inside every device, and data converters, which turn sensor voltages into numbers and back. Analog chips are often made on older, larger nodes, where transistors handle higher voltages and less noise, and in-house fabs such as TI's 300 mm analog fabs keep costs down.
Famous analog chips
Further reading
Photo credits on this page
The small pictures above come from Wikimedia Commons under free licences. Some are cropped to fit.
- LM317: Raimond Spekking, CC BY-SA 4.0, source
- 555 timer IC: Raimond Spekking, CC BY-SA 4.0, source
- 78xx: Raimond Spekking, CC BY-SA 4.0, source
- TL431: Raimond Spekking, CC BY-SA 4.0, source
- LM386: Raimond Spekking, CC BY-SA 4.0, source
- ΜA741: Teravolt ( talk ), CC BY 3.0, source