HD64180
A Z80-based embedded microprocessor with on-chip MMU and peripherals
The HD64180 is a Z80-based embedded microprocessor developed by Hitachi, appearing in 1985. It integrated a memory management unit and on-chip peripherals, and was later licensed to Zilog as the Z64180 and Z180.
- Z80-based embedded microprocessor from Hitachi, launched in 1985
- On-chip MMU addressing 512K bytes, or 1 MB in the PLCC package
- Block instructions run in 14 t-states per iteration instead of 21
- Two-channel DMA, serial ports, timers and interrupt controller on die
- Licensed to Zilog as the Z64180 and later the Z180
What it is
The HD64180 is an 8-bit embedded microprocessor built around the Z80 instruction set. Hitachi introduced it in 1985 as a higher-integration part sometimes called the Super Z80. It combined a memory management unit, direct memory access, serial ports, timers and interrupt control on one die, so a small computer or control system needed fewer support chips. It understands the 8080, 8085, Z80 and NSC 800 instruction sets. Hitachi later licensed the design to Zilog, which sold it as the Z64180 and, with improvements, as the Z180.
How it came about
Hitachi developed the HD64180 to extend the Z80 into embedded systems that needed more memory and built-in I/O. It reached the market in 1985. The design was licensed to Zilog, which resold it as the Z64180 and then refined it into the Z180. Machines such as the Micromint SB180 and SemiDisk Systems DT42 CP/M computers adopted it, along with Olivetti videotypewriters and upgrade boards for the TRS-80 Model 4.
Inside the chip
A pipelined execution unit runs most instructions in fewer clock cycles than a standard Z80. Block instructions such as LDIR, CPIR, INIR and OTDR drop from 21 transition states per iteration to 14. The MMU maps up to 512K bytes, or one megabyte in the PLCC package, and I/O space covers 64K addresses. Twelve new instructions include 8-bit by 8-bit multiply, a non-destructive AND and an illegal instruction trap. On-chip hardware adds a two-channel DMA controller, wait state generator, DRAM refresh, two serial channels, a 16-bit timer pair, a clocked serial port and vectored interrupt control.
How it was made
The HD64180 was built on a 1.3 µm process. It was supplied in packages including a 64-pin dual in-line package and a PLCC, the latter allowing the larger one megabyte memory map.
Where it went
The Micromint SB180 and the SemiDisk Systems DT42 ran CP/M on this processor. Olivetti used it in the CWP 1 and ETV 210 videotypewriters with ROM-based CP/M 2.2. An upgrade board for the TRS-80 Model 4, the XLR8er, fitted one, and its wait state generator helped handle that machine's awkward keyboard. Victor's HC-90 and HC-95 MSX2 computers carried an HD64B180 to provide a turbo mode alongside a normal Z80.
Versions and family
The HD64B180 appeared in MSX2 computers for faster operation. Hitachi's design was licensed to Zilog and sold there as the Z64180, then enhanced as the Zilog Z180.
Why it matters
By folding memory management, DMA and serial I/O onto the processor, the HD64180 let designers build compact Z80-compatible systems with fewer chips. Its instruction timing improvements, especially on block moves, made data transfer faster. The licensed Zilog versions carried the concept further and kept the architecture in production.
Problems and reception
The chip refuses the Z80's undocumented instructions, notably those splitting the IX and IY index registers into 8-bit halves. It treats them as illegal and traps, resetting the program counter to zero so execution restarts at the power-up address, which some existing Z80 software could not tolerate.

Questions people ask about HD64180
What is the HD64180?
It is an 8-bit embedded microprocessor from Hitachi, based on the Z80 instruction set. Launched in 1985, it adds a memory management unit and several on-chip peripherals, so a system needs fewer external support chips than a plain Z80 design.
How much memory can it address?
The memory management unit supports 512K bytes of memory. When the chip is packaged in a PLCC, that figure rises to one megabyte. I/O space covers 64K addresses.
Is it faster than a Z80?
Its pipelined execution unit finishes most instructions in fewer clock cycles. Block instructions such as LDIR and CPIR take 14 t-states per iteration on the HD64180, against 21 transition states on the Z80. Clock rates reach up to 10 MHz.
Will it run all Z80 software?
Not always. It does not execute the Z80's undocumented instructions, especially those using IX and IY as 8-bit halves. It treats them as illegal and traps by setting the program counter to zero, which behaves like a cold restart.
What is its link to the Zilog Z180?
Hitachi licensed the design to Zilog, which sold it as the Z64180. Zilog then produced an enhanced version, the Z180, which continues the same architecture.
Good reading and sources
- Hitachi HD64180 on WikipediaEncyclopedia
- More photos on Wikimedia CommonsPhotos
- Wikidata recordOpen data
The facts on this page come from the Wikipedia article "Hitachi HD64180", written by its contributors and used under the CC BY-SA 4.0 licence, and from its Wikidata record (CC0). EveryChip rewrote the text in its own words, with AI assistance, and compares every page with the article to make sure no passage is copied. It may be reused under the same CC BY-SA 4.0 licence with a link back.
It may contain mistakes, and figures change over time. Nothing here is investment or buying advice. If something is wrong, tell us. Last refreshed 2026-11-14.
Like HD64180
All CPUs and microprocessors
🇯🇵 JapanHitachi 6309
Hitachi's CMOS 8-bit microprocessor, a faster and richer 6809CPU · 8-bit · 1985
🇺🇸 United StatesIntel 8008
Early 8-bit microprocessor from Intel, launched April 1972CPU · 8-bit · 1972
More from Hitachi
All of them
🇯🇵 JapanNEC V20
Pin-compatible 16-bit microprocessor with Intel 8088 compatibilityCPU · x86 · 1984
🇯🇵 JapanHD63484
Hitachi graphics chip from 1984 supporting 4K monochrome outputGPU · 1984