DDR5 SDRAM
Fifth-generation synchronous DRAM standard with on-die ECC and dual subchannels
DDR5 SDRAM is the fifth generation of double data rate synchronous dynamic random-access memory, standardised by JEDEC and released on 14 July 2020 after an earlier 2018 target. It cuts module voltage to 1.1 V, doubles bandwidth over DDR4 and raises maximum DIMM capacity from 64 GB to 512 GB.
- Released 14 July 2020 by JEDEC, after a 2018 target
- Maximum DIMM capacity rises from 64 GB to 512 GB
- All DDR5 chips carry on-die error correction
- Two independent subchannels per module, each with its own command bus
- SK Hynix launched the first production DDR5 chip on 6 October 2020
What it is
DDR5 SDRAM is a synchronous dynamic random-access memory standard, the fifth in the double data rate line. JEDEC released it on 14 July 2020, having originally aimed at 2018. The design goal was lower power draw together with twice the bandwidth of DDR4. Transfer rates run from 4.0 to 8.8 GT/s, giving 32.0 to 70.4 GB/s, and clock rates sit between 2,000 and 4,400 MHz. A feature called Decision Feedback Equalization, or DFE, cleans up the input/output signals so the interface can be pushed faster. Latency stays near 14 ns, close to DDR4 and DDR3. Maximum module capacity rises eightfold, from 64 GB to 512 GB.
How it came about
Rambus showed a working DDR5 module in September 2017. SK Hynix completed its first DDR5 memory chip on 15 November 2018, running at 5.2 GT/s on 1.1 V, then reached 6.4 GT/s in February 2019, the top speed named in the draft specification. The standard itself arrived on 14 July 2020, and SK Hynix launched the first production DDR5 chip on 6 October 2020. A separate low-power variant, LPDDR5, for laptops and phones, was standardised in February 2019.
Inside the chip
Each module carries two independent subchannels instead of one shared channel, each with its own command/address bus and 32 data bits for non-ECC parts. Burst length doubles to 16, keeping a 64-byte minimum access that matches the cache line of modern x86 chips. Every chip has on-die error correction, fixing storage faults before data reaches the CPU, though it reports nothing outward. Bank groups rise to eight, one extra column bit is added, and the lowest three column bits are dropped. Commands use a 14-bit bus over one or two cycles, and 256 8-bit mode registers replace eight 13-bit ones. Refresh intervals tighten to 32 ms below 85°C.
How it was made
The specification sets a nominal 1.1 V, down from DDR4's 1.2 V, with real levels handled by regulators mounted on the module itself. Modules take 5 V (UDIMM) or 12 V (RDIMM/LRDIMM) input plus 3.3 V for management, and a power management IC plus passives convert this down near the chips. Standard parts are supplied as 288-pin DIMMs. Unbuffered UDIMMs wire the chip interface straight to the connector, while registered and load-reduced types buffer signals to lighten the bus load. The two families are keyed differently so they cannot be inserted by mistake.
Where it went
Intel's 12th, 13th and 14th generation Core desktop parts accept DDR5 alongside DDR4, though a board normally offers sockets for one type. Sapphire Rapids server chips, Meteor Lake mobile parts and Arrow Lake desktop chips take DDR5 only, with Arrow Lake also handling CUDIMM at 6400 MT/s. AMD supports it in Ryzen 6000 mobile APUs, Ryzen 7000 and Ryzen 9000 desktop CPUs, and fourth-generation Epyc server chips with 12 channels on Socket SP5. The Epyc 9006 series offers 16-channel DDR5 on Socket SP7 and eight channels on SP8.
Versions and family
Clocked unbuffered and clocked small-outline modules, CUDIMM and CSODIMM, appeared in 2024 with Intel Arrow Lake; they re-drive the clock to sustain higher speeds. AMD boards do not support CUDIMM, though Zen 5 accepts them in bypass mode. In 2026 ASRock and Intel released HUDIMM, a half unbuffered format filling one 32-bit subchannel per module for budget systems, needing UEFI support. Speed grades run from DDR5-4000 to DDR5-8800, and XMP profiles reach 8000 MT/s at 1.400 V or 1.450 V. DDR4 came before it; DDR6 is planned for 2028.
Why it matters
DDR5 raised the ceiling on desktop and server memory substantially, lifting the largest module from 64 GB to 512 GB and pushing standard transfer rates to 8.8 GT/s. Bandwidth of roughly 64 GB/s is available at 8.2 GT/s, and speeds above 13 GT/s have been reached with liquid nitrogen cooling. Its on-die error correction lets makers use denser chips with more defects, and the split subchannel design reshaped how controllers address memory. The standard now underpins mainstream Intel and AMD platforms.
Problems and reception
Latency remains around 14 ns, essentially unchanged from DDR4 and DDR3, so the gain comes from bandwidth rather than response time. On-die ECC drew attention because it corrects errors silently and gives no report to the CPU, unlike true ECC memory; analysts have had to infer corrected faults from uncorrected ones. Mixed DDR4 and DDR5 support on early Intel boards, and the separate CUDIMM and HUDIMM formats needing firmware backing, added complexity for buyers and builders.

Questions people ask about DDR5 SDRAM
Who created DDR5 and when did it appear?
JEDEC published the DDR5 standard on 14 July 2020, having originally targeted 2018. Rambus demonstrated a working module in September 2017, and SK Hynix produced the first production DDR5 chip on 6 October 2020.
How does DDR5 differ from DDR4?
It runs at 1.1 V rather than 1.2 V, doubles bandwidth, and lifts the largest module from 64 GB to 512 GB. Each module splits into two subchannels, burst length doubles to 16, and every chip gains on-die error correction. Latency stays near 14 ns.
What is on-die ECC?
Error correction built into each memory chip that finds and fixes storage faults before data is sent to the CPU. It needs no extra chips or lines and reports nothing back, unlike full ECC memory, so it mainly enables denser chips with more defects.
Which processors take DDR5?
Intel's 12th to 14th generation Core desktop chips accept it alongside DDR4, while Sapphire Rapids, Meteor Lake and Arrow Lake use it only. AMD supports it in Ryzen 6000 mobile, Ryzen 7000 and 9000 desktop, and fourth-generation Epyc server processors.
How fast can DDR5 run?
Standard grades span 4,000 to 6,400 million transfers per second, with the specification listing up to DDR5-8800. XMP profiles reach 8000 MT/s at raised voltages, and beyond 13 GT/s has been achieved using liquid nitrogen cooling.
Good reading and sources
- Official websiteOfficial site
- Next-generation DDR5 RAM will double the speed of DDR4 in 2018Ars Technica, Article
- Checking your browserAnandTech, Article
- SK hynix Launches World’s First DDR5 DRAMHPCwire, Article
- DDR5 Specification Released: Fast RAM With Built-In Voltage RegulatorsTom's Hardware, Article
The facts on this page come from the Wikipedia article "DDR5 SDRAM", written by its contributors and used under the CC BY-SA 4.0 licence, and from its Wikidata record (CC0). EveryChip rewrote the text in its own words, with AI assistance, and compares every page with the article to make sure no passage is copied. It may be reused under the same CC BY-SA 4.0 licence with a link back.
It may contain mistakes, and figures change over time. Nothing here is investment or buying advice. If something is wrong, tell us. Last refreshed 2026-11-14.
Like DDR5 SDRAM
All memory chips
🇺🇸 United States3D XPoint
Non-volatile memory from Intel and Micron, sold as OptaneMemory · 2015